Taxas Instruments TI AWR1443BOOST EVM: mmWave Demo Visualizer 按”SEND CONFIG TO MMWAVE DEVICE” 若沒反應怎麼處理?

AWR1443, AWR1243 Evaluation Module
(AWR1443BOOST, AWR1243BOOST) mmWave
Sensing Solution User’s Guide: 

A closed jumper refers to a 1 and

an open jumper refers to a 0 state

of the SOP signal going to the AWR device.

Jumper

101 (Short/Open/Short) = Flash programming

001 (Open/Open/Short) = Functional mode

 

mmwave_sdk只能安裝2.1版

安裝3.6版會沒有

xwr14xx_mmw_demo.bin可以燒錄

AWR1443需要燒錄xwr14xx

mmwave_sdk 3.6最低從

xwr16xx_mmw_demo.bin

無正確的bin檔可以燒錄

 

AWR1443BOOST

Jumper = 101 (Flash programming)

After changing the SOP mode, power off/on the EVM

 

For flashing you will need to use in Uniflash the User Port: – COM3

(裝置管理員中User UART結尾的那一個COM)

Settings： COM3

Meta image1:  xwr14xx_mmw_demo.bin => Load Image

(依個人硬體選擇正確的bin檔)

成功的話,Uniflash最底下應該出現

綠色的Program Load completed successfully

 

未選擇正確bin檔的話,

燒錄會出現Error

就算Program Load completed successfully也無效

xwr14xx_mmw_demo.bin 

 

After flashing,

change the SOP mode to Functional Mode

(SOP mode 4: 001)

SOP 0 has a jumper,

SOP 1,2 are not connected

After changing the SOP mode,

power off/on the EVM

 

mmWave Demo Visualizer

Platform: xWR14xx

SDK version: 2.1

按”SEND CONFIG TO MMWAVE DEVICE”

(左下角: Hardware Connected)

console messages會跑出一堆資訊

點Plots也會有圖: